Skip to main content
X-VENTISO home

Searches every page and every manual, submittal and spec sheet on the site. Try XV250 weight, gas interlock or BACnet.

Custom Solutions

Custom, by request

Every X-VENTISO system is sized for its project. When a project needs something the catalog doesn't show, we work it out with you: adapters, lengths, controls, and integration, built to the same standard as everything else we ship.

What we customize

If It Isn't on the Site, Ask.

  • Flue

    Custom Adapters

    Draft inducer and damper adapters made to the flue, by request, when a standard adapter doesn't fit.

    XV Series specifications
  • Wiring

    Custom Cable Lengths

    One continuous run from draft inducer to controller, cut to the job instead of joined with extensions.

  • Silencers

    Collars Matched to the Flue

    WSPRDraft collars sized to the pipe, including 13" Earthcore Eco-Steel all-fuel pipe.

    WSPRDraft Silencers
  • Proving

    Factory Test Port Flue Length

    A flue section with a built-in probe port, so no one has to drill a listed vent. Available exclusively through X-VENTISO. Specifying another vent brand? Call us and we'll work out the run with you.

  • Multi-flue

    Two, Three, or Four Flues

    WBC-DUO and GBC-DUO run two flues as one system; Meridian DUO controls each flue on its own. For three or four flues, XV-INTG links any X-VENTISO controllers on one call; XV-MULTICTRL can also put two Controlled Power controllers on one MUC.

    Controlled Power DUO
  • Integration

    Building and Home Automation

    BACnet and Modbus on Meridian and VMASS. On and off control for Controlled Power from a switch, a remote, or home automation.

Beyond the fireplace

Specialty Appliances Welcome.

XV Series draft inducers are listed for gas, solid fuel, and grease, and rated to 1,000°F continuous. That opens the door to more than fireplaces: wood-fired ovens, specialty grills and rotisseries, and other appliances that need proven draft.

If you are venting something unusual, send us the appliance and the flue route. We will tell you what it needs, or what it would take.

Custom, by request. The answer starts with yes, and the details start with your drawings.

How it works

From Question to System.

  1. Step 1: Tell Us the Job

    Send plans, photos, or a sketch, with the appliance and the flue route.

  2. Step 2: We Work It Out

    Sizing, equipment, and anything custom the project needs.

  3. Step 3: We Confirm It

    Drawings and submittals before anything is built.

  4. Step 4: You Install

    Factory-wired, plug-in connections, with support on call.